A multi-pass direct shear test can be configured to record during return to home or home plus passes.
To do this the shear test setup parameters needs to be configured as follows.
NOTE: If a multi-test is stopped before all passes have been completed, the remaining pass cannot be continued automatically. They will have to be run individually.
Use greater than with your horizontal input.
Residual Passes = Start at home
Record Reverse Values = TRUE
Record Reverse Value – Reverse Limit = The horizontal position at which you would like the machine to reverse.
Stop Type = Others
Condition = Less Than
Input = Horizontal
Value = Same as start condition. You can specify this to be less than the trigger value if you would like the test to be reverse further.